CompanyLogo
Search Advanced Search
Categories
General Questions (55)
Studio Series (29)
Shuttle Series (6)
Evolution Series (40)
G-DRIVE Family (41)
G-RAID Family (51)
G-SPEED/G-SAFE Family (52)
G-CONNECT (53)
G-MINI (15)
G-SATA (13)
Search
Advanced Search
FAQs
Search our FAQ to find resolutions to common issues.
Can I boot using the PCIe card that ships with the G-SPEED eS?
The raid controller card that ships with the G-SPEED eS does not support boot up.


Print  Email  Save  Notify Me  Delete from Favorites 
Article ID: 3 Article Created: 08-06-2009 21:50 PMLast Modified: 08-06-2009 21:50 PM

How well did this article answer your question? 100% 75% 50% 25% 0%

Most Recently Viewed Articles
How to set up a RAID 0?
To create a RAID 0 set, open the Disk Utility program. This application is located on your hard drive under Applications/Utilities/Disk Utility....
Will a PCMCIA / Cardbus adapter card power my G-Drive Mini or G-Raid Mini?
Most PCMCIA and Cardbus adapters PC 32/54 cards are not designed to POWER external devices....
Safely Ejecting Your G-Technology Drive
 How to properly eject your drive before disconnecting or powering off....
How to format your drive for use with both Windows and Mac (FAT 32)
 Follow these steps to format your drive for both Windows and Mac...
How do I setup my drive for use as a Time Machine backup?
In most cases when a new drive is connected to the system Time Machine will prompt you for the setup. If this does not   happen or if you are... ...
How do I change the RAID settings on my G-RAID Studio(MAC)?
 Instructions on installing and changing the RAID settings for the G-RAID Studio....
External Drive Troubleshooting - Mac
Basic steps for troubleshooting your G-Technology external drive on the Mac...
Replace a Failed Drive Module/Rebuilding RAID 5 for G-SPEED Q
  ...
How to set up a RAID 1?
To create a RAID 1 set, open the Disk Utility program. This application is located on your hard drive...
Using RAID Modes
This article contains instructions on how to use G-Technology RAID Configuration Utility....